5 Way Adaptor for the Henri Studio Classic Lion Fountain

I had a helpful conversation with one of your staff about having just bought a new 2100 replacement pump from you and my original Henri 3 way valve not fitting. I cannot get the 'adaptor' out of the old pump, if I order a replacement Henri 3 way valve from you, will it fit directly into the new 2100 pump I have already bought - i.e. does it have the right size thread etc.?

Dear Adrian Thank you for your question. I can confirm this adapter fits perfectly onto the Bermuda 2100 feature pump. Should you wish to contact us further or to place an order, please call us on 0121 355 7701. Thank you for using our online Q&A system. Kind regards Andy.Ilsley

I need to see if the Henri 3 way adapter will fit onto my present pump, what is the diameter of the thread connection?

Dear Mike Thank you for your question. The screw thread is 1 inch on this item. Should you wish to contact us further or to place an order, please call us on 0121 355 7701. Thank you for using our online Q&A system. Kind regards Paul Ilsley

Will the Henri 3 Way Adaptor fit into the Bermuda 1590 pump?

Dear Mike Thank you for your question. The Henri Three Way Adapter will require a Bermuda 2100 upwards to fit the thread. Should you wish to contact us further or to place an order, please call us on 0121 355 7701. Thank you for using our online Q&A system. Kind regards Dan Everton

I am installing an Ambient 120cm water feature waterfall has 3 inlets. Can you suggest a suitable pump that will sit 3ft deep,.just off bottom of my koi pond?

Dear Des Thank you for your question. We would need to know the width of the feature as well as its height to correctly advise you, If it is possible please take a picture of the feature and email it to us along with the measurements to [email protected] and then we can best advise you. Should you wish to contact us further or to place an order, please call us on 0121 355 7701. Thank you for using our online Q&A system. Kind regards Nathan James Dodd

I have a Henri water feature, approx. 5 ft tall. 3 fountains, one top, one middle, one near bottom. Base is a large bowl surrounded by animal, frogs etc., then there's a bridge and lady sat on a bench so bottom flow goes under that, then a rock face/mountainside waterfall with small pool and at the top the water feed to the waterfall itself. I would like to get this back up and running but I need a pump and hoses. If I remember correctly the original hoses came from the main feed and then there were metal clamps on each hose that you screwed to restrict the water to get the balance out of the 3 fountains. I now need the pump, hoses and clamps, can you please advise?

Dear Ros Thank you for your question. Thank you for your detailed description, however it's probably best if you send a picture of the fountain to [email protected] so we can ascertain the correct model and then we will look into this for you. Should you wish to contact us further or to place an order, please call us on 0121 355 7701. Thank you for using our online Q&A system. Kind regards Debi Roe