1 Inch Brass Gate Valve PN10

This 1 inch gate valve can regulate the flow of water passing through it with ease and safety, up to a full halt of the water using its very simple but well-built design. 

By turning the red knob found at the top of the valve, you will notice the gate inside the valve either raise or lower. Once water is flowing through the valve, and you turn this gate all the way down, the water will not be able to pass through. By having this gate at differing heights, you are able to control how much water is flowing through the valve. If the gate is fully open, the maximum amount of water is flowing through it.

This would prove useful in a plethora of applications such as plumbing, oil & gas, pharmaceuticals, automotive, manufacturing or simply as a flow adjuster to control the flow of water through a pump or filter once the valve has been connected to the relevant airways or piping.

1 Inch Gate Valve Features:

• Solid Brass Construction
• Bidirectional, Able to Manage Flow in Both Directions
• Narrow Gauge
• Avoids Water Hammer As It Closes in a Slow and Proportional Manner
• Thread Connections: Female/Female
• PN (Pressure Nominal): 10
• Expertly Manufactured in Italy

Dimensions:

• Length: 3.7cm
• Width: 4.4cm
• Height: 10cm

Dimensions are approximate and taken from the widest points excluding the knob.