Oase Aquamax Eco 5500 Rotor / Impeller

Product Code: 11657

Write the first review

Description

 

Replacement Oase Aquamax Eco 5500 Rotor / Impeller

 

Delivery Information

FREE Mainland UK* Delivery on orders over £40.00.
or £4.95 Delivery on Orders Under £40.00.
 £6.95 Next Working Day Delivery.

 *Additional delivery charges may apply to the following destinations: Isle of Wight, Isles of Scilly, Northern Ireland, Republic of Ireland and Scottish Highlands. Please contact us for a customised delivery quote.

Some spares may need to be ordered from Oase Germany and this can extend delivery slightly.

Customer Reviews

There are currently no reviews for this product. Please help us and others by writing a review.

Review This Product

Questions and Answers (3)

Fred Asked:

My Aquamax 5500 is a few years old now and seems to be OK but isn't moving the volume of water it used to. Is a replacement Rotor/Impeller likely to cure this?

We Replied:

Dear Fred Thank you for your question. We would suggest removing the impeller and checking for faults on the shaft and the blade. If the white fan head is worn or there are grooves in the shaft, it will need replacing. If it is not worn then the motor is at fault and will need replacing ether under warranty if applicable or by buying a new motor. Should you wish to contact us further or to place an order, please call us on 0121 355 7701. Thank you for using our online Q&A system. Kind regards Paul Ilsley

Sunday 12th, July, 2015
Leonard Newcombe Asked:

Should the impeller be snug within the housing?

We Replied:

Dear Leonard Thank you for your question. There should be a gap of around 2-4mm around the impeller and the housing, If the rotor is turning when the motor is on, it could be a case that the motor has developed dead spots within its brushes. The only real way to tell if an impeller is faulty is if the impeller is pitted or grooved on the metallic shaft that could cause intermittent faults with the pump. Should you wish to contact us further or to place an order, please call us on 0121 355 7701. Thank you for using our online Q&A system. Kind regards Dan Everton

Monday 07th, August, 2017
David Livesey Asked:

Where do you get the tool to remove the four securing screws holding casing so the impeller can be checked?

We Replied:

Dear David Livesey Thank you for your question. You require a torx screwdriver set to gain access into the impeller casing. These are readily available at DIY stores and online. Should you wish to contact us further or to place an order, please call us on 0121 355 7701. Thank you for using our online Q&A system. Kind Regards Dan Everton

Thursday 21st, September, 2017

Have a question for this product? Go ahead and ask us! We try to reply within a few hours but it may take longer on some questions.

Ask us a Question